Due to the PACT Act, we removed all concentrate vaporizers and accessories from the Planet of the Vapes website, and you should know why. We still stand behind these products, and plan to bring them back later, but for now we have stopped shipping concentrate vaporizers.
If you’re using your Puffco Peak Pro as much as we are, a deep cleaning is just around the corner. We’ll walk you through all the steps to a fresh, clean vaporizer.
Puffco Peak Pro Cleaning Guide: What you’ll need
Cleaning your Peak Pro will only require these few household items
- Rubbing alcohol
- Small dish or bag for soaking
Disassemble
The Peak Pro needs little disassembly for a deep cleaning. The chamber stays together as one piece, so unscrew it with a counterclockwise twist from the base and set it aside. Remove the glass carb cap insert from the rubber piece and set it to the side as well. Then, detach the bubbler by pulling it up and away from the base until it dislodges, and dump out the dirty water.
Soak and rinse
Take your small container and soak the chamber and carb cap in rubbing alcohol for a few hours. Then, take the bubbler and fill it a little under halfway with alcohol. Cover the top with one hand and give it a good shake to loosen up any gunk.
Buildup may occur inside the intake hole, so fill it with rubbing alcohol and give it a good shake as well. Tough messes may need a longer soak. Once everything is nice and clean, give the bubbler a thorough rinse and set all the pieces out to dry.
Reassemble
Once everything is completely dry, take the bubbler and fill it up with water, just past the internal air holes. Then, line the air hole on the bottom of the glass with the internal airpath on the base, and push and secure it back into place.
Slip the rubber seal around the carb cap and then take the chamber and screw it clockwise onto the base until it’s nice and tight. It should only take a quarter turn.
Run a burnoff
Before your next session, run a burnoff for a final cleanse of any leftover residue. Turn your Peak Pro on and set it to any temperature. Double-click and then let it run a full session before loading up your first hit.
Tips for cleaner vape
To keep your Peak Pro cleaner for longer, try not to load more concentrate than you’ll use in a session. Loads that don’t completely vaporize will stick and solidify inside the chamber. After each hit, clean out the chamber with a cotton swab before any leftover residue hardens. Same thing with the glass - rinse out and replace the water after a few sessions to keep it nice and clean.
